78D0011
35
WDV Series Gas Fireplace
The Logo Bar contains the brand logo: Signature Com-
mand System.
n Initialization and Setting up
Figure 42
The remote transmitter has
two battery compartments,
one on each end of the trans-
mitter.
To install batteries,
1. Press down the battery
door tab and pull out to re-
move the battery door.
. Install the batteries as indi-
cated inside the battery compartments.
3. Close the battery door by snapping in place.
4. When all batteries are installed, the transmitter
will initialize for 5 seconds and then is ready for use.
5. The batteries should be replaced every 1 months or
when the low battery icon indicator is displayed.
When batteries are installed in the transmitter,
1. All available icons on the LCD will be turned on then
be cleared.
. The LCD will display temperature unit: °F. Use ON ∆
to toggle the units between °F and °C within the rst 5
seconds.
3. The transmitter enters Manual Mode
4. The LCD displays room temperature with the chosen
unit.
Information
Bar
Touch Area
Logo
Bar
Menus
Adjustment
Controls
Figure 41
n Function Areas of the LCD Display
Figure 41 shows the display of the TSFSC LCD.
The information bar shows the room temperature, the
“sending signal” radio icon, the low battery indication icon,
the child-proof icon, and the ame icon. This area doesn’t
have touch buttons.
• The room temperature will always be shown after
power-up. It displays the room temperature from 40
°F to 99 °F. “Lo” and “HI” will be displayed when the
room temperature is lower than 40°F or higher than
99°F, respectively.
• The radio icon will be shown when the transmitter is
sending a signal.
• The low battery indication icon will be shown when
the battery voltage is low.
• The child-proof icon will be shown when the child-
proof mode is activated.
• The ame icon indicates the current ame height
- Off, Low, Medium and High
The touch area contains all touch buttons to control the
transmitter. It consists of two categories: menus and ad-
justment arrows. The blue LED backlight lights up for 8
seconds when any of the touch buttons is pressed.
• The menus include TIMER, THERMO, LIGHT, FAN
and AUX.
• The adjustment arrows include ON/up and OFF/
down. Their default function is to adjust the ame
height. When a button from the menu is pressed,
the ON/up and OFF/down buttons will temporarily
become adjustment controls for the selected item.
When the adjustment is done, the ON/up and OFF/
down buttons go back to ame height controller
again.
Battery Door
Tabs
Figure 42
Comments to this Manuals