Monessen Hearth GPF36 Operations Instructions download pdf (Page 17)

43D0121 17

Black

White

Blower

Plug

Junction Box

Factory Supplied

Not Supplied

Green

Black

120 VAC

Blower

120 VAC

Speed Control

ON/OFF

Wall

Switch

120 VAC/60 Hz

BTS

CAUTION

Electrical connections should only be performed by a qualified, licensed electrician,

main power must be off when connecting to main electrical power supply or

performing service.

The blower when installed, must be electrically grounded in accordance with

local codes or in the absence of local codes, with the National Electrical Code

ANSI/NFPA 70.

BLOWER INSTALLATION

Install blower before framing firebox. Remove access panel on the floor of the firebox before installing the blower.

See Figure 30, page 18.

WIRING TO JUNCTION BOX

NOTE: The wire must be run to the junction box before framing the firebox.

1. Before installing blower, wire the receptacle into an electrical circuit. Use minimum 60°C wire in accordance

to prevailing codes.

2. The junction box is preinstalled at the factory. Remove external junction box cover by removing the screw from either

the left or right side of the outside firebox wall.

3. The junction box cover has a factory-installed “romex” style strain relief connector. Connect the wires according to the

wiring diagram below. Route the connected wire leads through the strain relief connector. See Figure 25.

Figure 25 - Wiring Diagram for Junction Box

Continued on page 18

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

Monessen Hearth GPF36 Operations Instructions Page 17